If resin has gotten on the hall floor, use a resin remover to wash the floor. For 2-component lacquers and rubber floors use Harpiksfjerner pro. For all other surfaces use Harpiksfjerner special. The product can advantageously be used in a spray applicator (remember respiratory protection with an ABEK1 filter).

Dosage of resin remover:

• Use the recommended dosage in the applicator. Use cold or lukewarm water.
• Divide the sports hall into 3 equally sized areas. Apply resin remover to the first third and let it act for a maximum of 5–10 minutes.
• Rinse afterwards with Drynal Pro using a floor scrubber
• Then continue with the next third until the entire hall is cleaned.
• It is recommended to use personal protective equipment such as respiratory protection.

If Harpiksfjerner Pro is applied with a floor scrubber, the surface must be rinsed after the dwell time with Drynal Pro in the floor scrubber to neutralize the resin remover and remove the dissolved resin from the floor.

How to clean the hall floor daily

Hall floor with a 2-component lacquer or rubber surface:

For daily cleaning use Drynal Pro.
If there is resin, use Harpiksfjerner pro.

Hall floor with a 1-component lacquer (water-based):

For daily cleaning use Drynal Pro.
If there is resin, use Harpiksfjerner special.

Linoleum hall floor:

For daily cleaning use Gulvplejemiddel pro or Gulvrengøringsmiddel pro depending on wear and age. Alternate washing as needed with Drynal Pro if excess care film builds up. If there is resin, use Harpiksfjerner special.